Thin to High Build Fire Resistant Surface Coating
- SBS-1607 coating does not burn under direct flame contact
- SBS-1607 has no flame spread and no smoke or toxic fumes are generated
- SBS-1607 material has excellent adhesion properties to most common substrates*
- SBS-1607 can be applied by trowel or similar tools, as well as texture spray gun systems
- SBS-1607 may be applied in layers** to create a higher film build.
Contact Nick Gencarelle for product information and pricing (phone +1 401 481 8422)
SBS-1607 Flame-Shield Technical Properties |
|
---|---|
Color | Speckled brown (may vary) |
Odor | No odor once cured |
VOC | None |
RoHS | Complaint |
REACH | Compliant |
Halogens | None |
Percent of Solids | Approx. 75% |
Theoretical coverage of 5-mil layer | 250.sq/ft/gal |
Flash Point | N/A |
Flame Contact | Non-flammable & self extinguising |
Clean Up | Water while wet |
Dry Time*** | Dependent on product thickness, ambient temperature and humidity |
SBS-1607 Mixing and Application
Keep the A & B containers sealed until ready to use.
- Part-A;
- Shake the contents to ensure all contents are suspended uniformly before pouring contents into the Part-B material/container.
- The following volume options are suggested for adding the “Part-A Liquid material” to “Part-B Dry Goods material”.
- Adding of the “Part-A Liquid material” supplied in the “Part SBS-1607 Half gallon kit
- Putty consistency – Mix at a 2:1 ratio (930g/22-oz Part A to all of Part B)
- Trowel consistency – Mix at a 3:1 ratio (1000g 24-oz Part A to all of Part B)
- Self-leveling – Mix at a 3.5 :1 ratio (1030g/25-oz Part A to all of Part B)
- Adding of the “Part-A Liquid material” supplied in the SBS-1607 One gallon kit
- Putty consistency – Mix at a 2:1 ratio (1860g/44-oz Part A to all of Part B)
- Trowel consistency – Mix at a 3:1 ratio (2000g/48-oz Part A to all of Part B)
- Self-leveling – Mix at a 3.5 :1 ratio (2060g/50-oz Part A to all of Part B)
- Adding of the “Part-A Liquid material” supplied in the “Part SBS-1607 Half gallon kit
- Immediately stir or power mix the mixture of both A & B, being sure all solids are wetted uniformly.
- If thinning is required – for a specific application need – add water in very small (1-ounce or less) amounts at a time to achieve the needed viscosity.
- Do not over thin as dry time will be extended and possibly create some surface fractures within the cured coating.
- Clean tools and equipment with water – prior to the drying of the product
NOTES:
* Some hard to bond to substrates, the use of SBS-520 adhesion primer maybe required.
** Multiple-layered application; the preceding SBS-1607 coating layer should be cured prior to overcoating with SBS-1607.
*** As the product’s applied mil thickness increases, it will extend the required time to cure the product.
SBS-1208 or similar SBS-nano-ceramic coating product may be used as a top coat to create a thin no-burn, hydrophobic clear coating film on the cured SBS-1607 surface.
Manufacturer is not responsible for the use and application of this material. It is up to the end user determine the suitability of this product for their own application. It is the belief that the contents of this document be accurate at the time of printing. No warranty is written or implied regarding application and use.